In Stock & Ready to Ship
EarthQuaker Devices Gary
-
Factory Setup
And Inspection -
Returns
Guitars & Basses (Online & Phone Orders)
We want you to be completely satisfied with your purchase. If you need to return a
guitar or bass, here’s what you need to know:- Returns must be initiated within 3 days of receiving your order.
- To initiate a return, call us at 412-343-5299 for a return authorization number.
- Return shipping is the customer’s responsibility, unless the item arrived damaged or the wrong product was sent.
- If your item shipped with “Free Shipping,” the original outbound shipping cost will be deducted from your refund.
- A 3.5% restocking fee applies to all canceled or returned orders to cover non-refundable payment processing fees.
- Items must be returned in original condition with all packaging materials included. For guitars and basses, that means protective plastic must still be intact on pickups and pickguards; all accessories, case candy, and paperwork must be included; original box and packing materials must be returned.
- We reserve the right to refuse returns or charge an additional restocking fee if items are not returned in original condition.
All Sales Final
We do not accept returns on the following:
- In-store purchases
- Local Pickup Orders (Buy Online / Phone)
- Layaway sales and payments
- Closeout or clearance items
- Purchases involving trades
- Instruments modified at the time of sale or after (example: strap button or pickup installation)
- Amps, Pedals & Electronics. Due to the nature of electronic products, we do not accept returns on amplifiers, pedals, or other electronic gear. If your item appears defective out of the box, contact us immediately — we’ll work with you and the manufacturer on a warranty resolution.
OTHER AVAILABLE SERIALS
Select a collection or products to display in the carousel
Description
EarthQuaker Devices Gary Automatic Pulse Width Modulation Fuzz and Dynamic Natural Overdrive
A collaboration between EarthQuaker Devices and Lee Kiernan from IDLES.
Gary started as a simple request to create a compact version of the now discontinued Gray Channel®, which was a mainstay on Lee’s board and a big part of his main drive tone. This was all fine and good, and sounded quite sick, but Gary was demanding that we look deeper and explore his dark side a little more, Gary after dark, Saturday night Gary. So, we sat him down and began the trek of figuring out old Gare-Bear once and for all. The result is a dynamic and destructive pulse width modulated fuzz paired with a natural-sounding op-amp overdrive.
Controls:
Go: Gain control for the overdrive. Turn this up to increase the opamp gain to a thick and full distortion, or turn it down and turn up That’s It to use it as a clean boost.
That’s It: Master volume for the overdrive side.
Left Footswitch: Overdrive
Yes!: Sets the sensitivity for the envelope that controls the duty cycle for the square wave fuzz. The envelope is highly dependent on the level of the incoming signal, which can be affected by any gain pedals in front of Gary, pickup strength, source instrument, etc.
Oosh: Master volume for the fuzz side.
Right Footswitch: Fuzz
The pedal comes with EarthQuaker Devices' Factory Warranty and our 100% satisfaction guarantee!
Specifications
-
Dimensions 4.75 x 2.50 x 2.25 Inches (121 x 64 x 57 mm) With Knobs
-
Current Draw 20 mA
-
Fuzz Input Impedance 1 MΩ
-
Fuzz Output Impedance < 1 kΩ
-
Overdrive Input Impedance 500 kΩ
-
Overdrive Output Impedance < 1 kΩ
-
TRS Expression Pedal Wiring Tip; Wiper, Ring; +3.3V, Sleeve; Ground
-
Switching Flexi-Switch® Technology (Momentary/Latching)
-
Bypass Relay-Based True Bypass
-
Power Supply 9 Volts DC (Standard 2.1 mm Negative Center Barrel)
-
Power Note Isolated Supply Recommended; Do Not Run At Higher Voltages
EarthQuaker Devices Gary
-
Dimensions 4.75 x 2.50 x 2.25 Inches (121 x 64 x 57 mm) With Knobs
-
Current Draw 20 mA
-
Fuzz Input Impedance 1 MΩ
-
Fuzz Output Impedance < 1 kΩ
-
Overdrive Input Impedance 500 kΩ
-
Overdrive Output Impedance < 1 kΩ
-
TRS Expression Pedal Wiring Tip; Wiper, Ring; +3.3V, Sleeve; Ground
-
Switching Flexi-Switch® Technology (Momentary/Latching)
-
Bypass Relay-Based True Bypass
-
Power Supply 9 Volts DC (Standard 2.1 mm Negative Center Barrel)
-
Power Note Isolated Supply Recommended; Do Not Run At Higher Voltages
-
Artwork Charlotte Gosch, studio other types
RECENTLY VIEWED ITEMS
